SEAFLO AUTOMATIC BILGE PUMP 600 GPH NEW DESIGN
The latest model of bilge pump, with electronic automatic mode. This means that it does not require the use of a float switch, as it has an electronic sensor that starts the pump. In automatic mode, the pump turns on for half a second every 2.5 minutes, using only 0.25 amps per day. When it senses resistance, it works until all the water is removed. It can be turned on manually using a switch. (connect the brown wire +)
- Voltage 12V
- Efficiency - 38l/min (600GPH)
- Pressing height below 2.5m (as per the diagram in the photo)
- Max current consumption - 2.5A
- Connector diameter - 19mm and 29mm
- Length of electric cable - 1m
- Weight 0.4/0.47kg
- Manufacturer code SFBP1-G600-13B
- The set includes a removable straight outlet connector with a nut and a non-return valve.
- Removable mesh filter facilitates removal of dirt in the rotor area
- Stainless steel motor shaft
- Ventilated rotor housing prevents air from entering the pump
- Fully submersible and flameproof
- Threaded outlet - easier installation, easier maintenance
- The engine can be purchased separately
- Pump and switch are internally wired for easy installation
- High efficiency, low amperage motor
- Includes a check valve to prevent water from flowing back
- Moisture-resistant seals
- Bilge water sensor and pump in one housing
- Sealed, efficient, long-life motors
- Marine grade silicone locking, tin coated wiring
- Quiet operation
- Compact automatic pump does not require a float switch
- Certificates CE, RoHS, ISO 8846, ISO8849
- Higher flow - 500 GPH pump with optimized impeller provides up to 10% more flow at the same rate
- The third wire allows manual control using a switch.
- Checks for water every 2.5 minutes, works for half a second, uses 0.25 amps per day
- There is no need to disconnect the base or plumbing when replacing the pump.